Table of Contents
Advertisement
6.1
Operating modes and status
Operating mode/status
Basic status
Stop
Stop by key
Stop via external stop
Chart speeds
Normal chart speed
Limit operation
External speed
6 Preparation
Description
Basic status of the recorder with signal acquisition and
processing.
The display shows, depending on setting:
- instrument designation, date and time
- one channel and its measurement as number
or bargraph
- or status/error messages.
The display can be altered during recording, using the
h
R
keys
and
.
If there is a status/error message, it is shown flashing at
regular intervals instead of the current display.
Recording is stopped and continued using key
In the stop status the display flashes STOP .
External stop can be operated through a signal at a
logic input on the back of the recorder. In the external
stop status the display flashes EXTERNAL STOP .
The chart is advanced at the speed programmed under
chart speed.
Section 8.2.1
When input goes above/below the programmed limits,
the recorder switches to the chart speed programmed
under "limit feed".
Section 8.4.5
Section 8.5.3
Section 10.4
On a signal applied to a logic input at the back of the
recorder, it switches to the chart speed programmed
under "feed extern".
Section 8.6.7
Section 10.4
20
S
.
Advertisement
Table of Contents
