Table of Contents
Advertisement
Operating mode/status
Timed operation
Recording
Scaling
Plotarea
Offset
Pen offset compensation
6 Preparation
Description
This chart speed applies within a programmable time
period. Outside this period the chart is advanced at the
speed programmed as normal speed.
Section 8.5.4
Section 10.4
The scale can be printed in two different modes:
cyclic:
for each channel at a configured spacing
triggered: for all channels by pressing key (key F,
hold down at least 4 sec) or by closing
a logic input
Section 7.4
Section 8.4.3
During plotarea operation a portion of the total measur-
ing range of a trace is recorded to a larger scale.
Section 8.4.6
Section 10.4
Using the parameter "offset" it is possible to define the
presentation range of a trace on the chart.
Section 8.4.7
Section 10.4
There is an offset of several millimetres between the
fibre pens of the individual channels.
When pen offset compensation is switched on, this pen
offset is compensated automatically.
Section 8.5.7
Section 10.4
21
Advertisement
Table of Contents
