Table of Contents
Advertisement
12.3 Hardware fault
In case of one of the following faults the re-
cording is aborted and the error message
flashes on the display.
The relays are operated as for probe break
The recorder does not react to any event
and can not be operated.
Please contact the nearest office or the factory.
Display
EEPROM FAULTY!
ADC FAULTY!
HALLSENSOR FAULTY!
1. The action on probe break is configured
using the setup program or the parameter
relay output (
Section 8.6.1).
12 Appendix
1
.
Cause / Remedy
The EEPROM in the recorder is faulty, the configuration
data can no longer be stored.
The A/D converter of the recorder is faulty.
The writing system is faulty.
127
Advertisement
Table of Contents
