Replacing The Wlan-Antenna Connectors; Procedure; Post-Requisites - Dell Embedded Box PC 5000 Service Manual

Replacing the WLAN-antenna
connectors
WARNING: Before working inside your Embedded Box PC, read the
safety information that shipped with your Embedded Box PC and
follow the steps in
After working inside your Embedded Box PC, follow the steps in
working inside your Embedded Box
see the Regulatory Compliance home page at
regulatory_compliance.

Procedure

1 Insert the WLAN-antenna connectors into the WLAN-antenna connector
slots on the bottom cover.
NOTE: Insert the WLAN-antenna connectors based on the color
indicated behind the bottom cover.
2 Replace the nuts and washers that secure the WLAN-antenna connectors
to the bottom cover.
3 Route the WLAN cables through the routing guides on the chassis.
4 Connect the WLAN-antenna cables to the WLAN card.
The following table provides the antenna-cable color scheme for the
WLAN card supported by the Embedded Box PC.
Connectors on the WLAN card
Main (white triangle)
Auxiliary (black triangle)

Post-requisites

1 Replace the PCI/PCIe card
2 Follow step 2 to step 9 in
Before working inside your Embedded Box
(if necessary).
"Replacing the back
PC. For more safety best practices,
www.dell.com/
Antenna-cable color
White
Black
cover".
PC.
After
55