Replacing the serial ports
WARNING: Before working inside your Embedded Box PC, read the
safety information that shipped with your Embedded Box PC and
follow the steps in
After working inside your Embedded Box PC, follow the steps in
working inside your Embedded Box
see the Regulatory Compliance home page at
regulatory_compliance.
Procedure
1
Connect the serial-port cable to the connector on the system board.
2
Insert the serial ports into the respective slots on the bottom cover.
NOTE: Match the port number with the number on the cable.
3
Replace the hexagonal screws that secure the serial ports to the bottom-
cover.
Post-requisites
1
Replace the
PCI/PCIe card
2
Follow step 2 to step 9 in
90
Before working inside your Embedded Box
(if necessary).
"Replacing the back
PC. For more safety best practices,
www.dell.com/
cover".
PC.
After