Replacing The Wwan-Antenna Connectors; Procedure; Post-Requisites - Dell Embedded Box PC 5000 Service Manual

Replacing the WWAN-antenna
connectors
WARNING: Before working inside your Embedded Box PC, read the
safety information that shipped with your Embedded Box PC and
follow the steps in
After working inside your Embedded Box PC, follow the steps in
working inside your Embedded Box
see the Regulatory Compliance home page at
regulatory_compliance.

Procedure

1 Insert the WWAN-antenna connectors into the WWAN-antenna
connector slots on the bottom cover.
NOTE: Insert the WWAN-antenna connectors based on the color
indicated behind the bottom cover.
2 Replace the nuts and washers that secure the WWAN-antenna
connectors to the bottom cover.
3 Route the WWAN cables through the routing guides on the chassis.
4 Connect the WWAN-antenna cables to the WWAN card.
The following table provides the antenna-cable color scheme for the
WWAN card supported by the Embedded Box PC.
Connectors on the WWAN card
Main (white triangle)
Auxiliary (black triangle)

Post-requisites

1 Replace the PCI/PCIe card
2 Follow step 2 to step 9 in
64
Before working inside your Embedded Box
(if necessary).
"Replacing the back
PC. For more safety best practices,
www.dell.com/
Antenna-cable color
White/gray
Black/gray
cover".
PC.
After