Before Working Inside Your Embedded Box Pc; Before You Begin; Safety Instructions - Dell Embedded Box PC 5000 Service Manual

Before working inside your
Embedded Box PC
NOTE: The images in this document may differ from your Embedded
Box PC depending on the configuration you ordered.

Before you begin

1 Save and close all open files and exit all open applications.
2 Shut down the Embedded Box PC.
The shut-down instruction varies depending on the operating system
installed on the Embedded Box PC.
NOTE: For more information, see the documentation of your
operating system for shut-down instructions.
3 Disconnect the Embedded Box PC and all attached devices from their
electrical outlets.
4 Disconnect all cables such as network cables from the Embedded Box
PC.
5 Disconnect all attached devices and peripherals, such as keyboard,
mouse, and monitor, from the Embedded Box PC.
6 After the Embedded Box PC is unplugged, press and hold the power
button for 5 seconds to ground the system board.

Safety instructions

Use the following safety guidelines to protect your Embedded Box PC from
potential damage and ensure your personal safety.
WARNING: Before working inside your Embedded Box PC, read the
safety information that shipped with your Embedded Box PC and
follow the steps in
After working inside your Embedded Box PC, follow the steps in
working inside your Embedded Box
see the Regulatory Compliance home page at
regulatory_compliance.
10
Before working inside your Embedded Box
PC. For more safety best practices,
www.dell.com/
PC.
After