Replacing The Top Cover; Procedure; Post-Requisites - Dell Embedded Box PC 5000 Service Manual

Replacing the top cover

WARNING: Before working inside your Embedded Box PC, read the
safety information that shipped with your Embedded Box PC and
follow the steps in
After working inside your Embedded Box PC, follow the steps in
working inside your Embedded Box
see the Regulatory Compliance home page at
regulatory_compliance.

Procedure

1 Place the top cover on the chassis and align the screw holes on the top
cover with the screw holes on the chassis.
2 Replace the screws that secure the top cover to the chassis.
3 Replace the hexagonal screws that secure the VGA port to the top cover.
4 Route the power-connector cable, grounding cable, and intrusion-switch
cable through the routing guides on the system board.
5 Replace the screw that secures the grounding cable to the system board.
6 Connect the power-connector cable and intrusion-switch cable to the
system board.
7 Route the power-switch cable through the routing guides on the chassis.
8 Connect the power-switch cable to the connector on the system board.

Post-requisites

1 Replace the PCI/PCIe card
2 Replace the riser
3 Follow step 2 to step 9 in
98
Before working inside your Embedded Box
(if necessary).
card.
"Replacing the back
PC. For more safety best practices,
www.dell.com/
cover".
PC.
After