Removing The System Board; Prerequisites - Dell Embedded Box PC 5000 Service Manual

Removing the system board

WARNING: Before working inside your Embedded Box PC, read the
safety information that shipped with your Embedded Box PC and
follow the steps in
After working inside your Embedded Box PC, follow the steps in
working inside your Embedded Box
see the Regulatory Compliance home page at
regulatory_compliance.
NOTE: Your Embedded Box PC's Service Tag is stored in the system
board. You must enter the Service Tag in the BIOS setup program after
you replace the system board.
NOTE: Replacing the system board removes any changes you have
made to the BIOS using the BIOS setup program. You must make the
appropriate changes again after you replace the system board.
NOTE: Before disconnecting the cables from the system board, note the
location of the connectors so that you can reconnect the cables
correctly after you replace the system board.

Prerequisites

1 Follow step 1 to step 6 in
2 Remove the
3 Remove the
4 Remove the
5 Remove the
6 Remove the
7 Remove the
8 Remove the
9 Remove the
10 Remove the
Before working inside your Embedded Box
"removing the back
PCI/PCIe card (if installed).
WLAN card.
CANbus card or WWAN
SIM card.
intrusion switch.
riser card.
top cover.
heat sink.
CPU board.
PC. For more safety best practices,
www.dell.com/
cover".
card.
PC.
After
105