Replacing the back cover
WARNING: Before working inside your Embedded Box PC, read the
safety information that shipped with your Embedded Box PC and
follow the steps in
After working inside your Embedded Box PC, follow the steps in
working inside your Embedded Box
see the Regulatory Compliance home page at
regulatory_compliance.
Procedure
1
Replace the
2
Insert the tabs on back cover at an angle into the slots on the chassis.
3
Open the back cover.
4
Route the SATA-power and SATA-data cables through the routing guides.
5
Connect the SATA-power and SATA-data cable to the hard drive or solid-
state drive assembly.
NOTE: Connect the cables to the second drive if installed.
6
Close the back cover.
7
Align the screw holes on the back cover with the screw holes on the
chassis.
8
Replace screws that secure the back cover to the chassis.
Before working inside your Embedded Box
Replacing the hard-drive
PC. For more safety best practices,
www.dell.com/
cage.
PC.
After
21