Replacing The Heat Sink; Procedure; Post-Requisites - Dell Embedded Box PC 5000 Service Manual

Replacing the heat sink

WARNING: Before working inside your Embedded Box PC, read the
safety information that shipped with your Embedded Box PC and
follow the steps in
After working inside your Embedded Box PC, follow the steps in
working inside your Embedded Box
see the Regulatory Compliance home page at
regulatory_compliance.

Procedure

1 Replace the thermal pads on the heat sink.
2 Place the heat sink on the CPU board.
3 Align the screw holes on the heat sink with the screw holes on the CPU
board.
4 In sequential order (indicated on the heat sink), replace the screws that
secure the heat sink to the CPU board.
5 Replace the screws that secure the chassis heat-sinks to the sides of the
chassis.

Post-requisites

1 Replace the riser
2 Replace the PCI/PCIe card
3 Follow step 2 to step 9 in replacing the
Before working inside your Embedded Box
card.
(if necessary).
PC. For more safety best practices,
www.dell.com/
"back cover".
PC.
After
101