Removing The Solid-State Drive From Bracket; Procedure; Post-Requisites - Dell Embedded Box PC 5000 Service Manual

Removing the solid-state drive
from bracket
WARNING: Before working inside your Embedded Box PC, read the
safety information that shipped with your Embedded Box PC and
follow the steps in
After working inside your Embedded Box PC, follow the steps in
working inside your Embedded Box
see the Regulatory Compliance home page at
regulatory_compliance.
CAUTION: Solid-state drives are fragile. Exercise care when handling
the solid-state drive.

Procedure

1 Align the notch on the solid-state drive with the tab on the solid-state
drive slot.
2 Slide the solid-state drive firmly into the slot and align the screw hole on
the solid-state drive with the screw hole on the solid-state drive bracket
3 Replace the screw that secures the solid-state drive to the solid-state
drive bracket.

Post-requisites

1 Replace the drives in to the hard-drive
2 Follow step 2 to step 8 in
Before working inside your Embedded Box
"Replacing the back
PC. For more safety best practices,
www.dell.com/
cage.
cover".
PC.
After
31