Replacing The Wwan Card; Procedure - Dell Embedded Box PC 5000 Service Manual

Replacing the WWAN card

WARNING: Before working inside your Embedded Box PC, read the
safety information that shipped with your Embedded Box PC and
follow the steps in
After working inside your Embedded Box PC, follow the steps in
working inside your Embedded Box
see the Regulatory Compliance home page at
regulatory_compliance.

Procedure

NOTE: To avoid damage to the WWAN card, do not place any cables
under it.
1 Align the notch on the WWAN card with the tab on the mPCIE1 slot.
2 Insert the WWAN card at an angle into the mPCIE1 slot.
3 Align the screw holes on the WWAN card with the screw holes on the
system board.
4 Replace the screws that secure the WWAN card to the system board.
Before working inside your Embedded Box
PC. For more safety best practices,
www.dell.com/
PC.
After
67