To configure the destination MAC address of the cluster management protocol packets:
To do...
1.
Enter system view.
2.
Enter cluster view.
3.
Configure the destination
MAC address for cluster
management protocol
packets.
4.
Configure the interval to send
MAC address negotiation
broadcast packets.
CAUTION:
When you configure the destination MAC address for cluster management protocol packets:
If the interval for sending MAC address negotiation broadcast packets is 0, the system automatically
•
sets it to 1 minute.
•
If the interval for sending MAC address negotiation broadcast packets is not 0, the interval remains
unchanged.
Cluster member management
You can manually add a candidate device to a cluster, or remove a member device from a cluster.
If a member device needs to be rebooted for software upgrade or configuration update, remotely reboot
it through the management device.
Adding a member device
To do...
1.
Enter system view.
2.
Enter cluster view.
3.
Add a candidate device to
the cluster.
Removing a member device
To do...
1.
Enter system view.
Use the command...
system-view
cluster
cluster-mac mac-address
cluster-mac syn-interval interval
Use the command...
system-view
cluster
add-member [ member-number ]
mac-address mac-address
[ password password ]
Use the command...
system-view
152
Remarks
—
—
Required.
The destination MAC address is
0180-C200-000A by default.
The following are the configurable
MAC addresses:
•
0180-C200-0000
•
0180-C200-000A
•
0180-C200-0020 through
0180-C200-002F
•
010F-E200-0002
Optional.
One minute by default.
Remarks
—
—
Required
Remarks
—