Snmp Configuration Synchronization Function - HP 5820X Switch Configuration Manual

To do...
7. Configure the NM interface of
the management device.
CAUTION:
To isolate management protocol packets of a cluster from packets outside the cluster, configure the
device to prohibit packets from the management VLAN from passing the ports that connect the
management device with the devices outside the cluster and configure the NM interface for the
management device.

SNMP configuration synchronization function

SNMP configuration synchronization function facilitates management of a cluster, with which you can
perform SNMP-related configurations on the management device and synchronize them to the member
devices on the whitelist. This operation is equal to configuring multiple member devices at one time,
simplifying the configuration process.
To configure the SNMP configuration synchronization function:
To do...
1. Enter system view.
2. Enter cluster view.
3. Configure the SNMP
community name shared by a
cluster.
4. Configure the SNMPv3 group
shared by a cluster.
Create or update information
5.
of the MIB view shared by a
cluster.
Add a user for the SNMPv3
6.
group shared by a cluster.
NOTE:
The SNMP-related configurations are retained when a cluster is dismissed or the member devices are
•
removed from the whitelist.
For more information about SNMP, see SNMP configuration in the
•
Monitoring Configuration Guide
Use the command...
nm-interface vlan-interface
interface-name
Use the command...
system-view
cluster
cluster-snmp-agent community
{ read | write } community-name
[ mib-view view-name ]
cluster-snmp-agent group v3
group-name [ authentication |
privacy ] [ read-view read-view ]
[ write-view write-view ] [ notify-
view notify-view ]
cluster-snmp-agent mib-view
included view-name oid-tree
cluster-snmp-agent usm-user v3
user-name group-name
[ authentication-mode { md5 |
sha } auth-password ] [ privacy-
mode des56 priv-password ]
.
157
Remarks
Optional.
Remarks
—
—
Required.
Required.
Required.
By default, the name of the MIB
view shared by a cluster is
ViewDefault and a cluster can
access the ISO subtree.
Required.
Network Management and