HP 5820X Switch Configuration Manual page 62

[DeviceA-nqa-admin-test-icmp-echo] quit
# Configure the test start time and test duration for the test group.
[DeviceA] nqa schedule admin test start-time now lifetime forever
On Device A, create the track entry.
4.
# Create track entry 1 to associate it with Reaction entry 1 of the NQA test group (admin-test).
[DeviceA] track 1 nqa entry admin test reaction 1
Verify the configuration.
5.
# On Device A, display information about all track entries.
[DeviceA] display track all
Track ID: 1
Status: Positive
Notification delay: Positive 0, Negative 0 (in seconds)
Reference object:
NQA entry: admin test
Reaction: 1
# Display brief information about active routes in the routing table on Device A.
[DeviceA] display ip routing-table
[DeviceA] display ip routing-table
Routing Tables: Public
Destinations : 5
Destination/Mask
10.1.1.0/24 Static 60 0
10.2.1.0/24 Direct 0
10.2.1.2/32 Direct 0
127.0.0.0/8
127.0.0.1/32
The output shows that the static route with the next hop 10.2.1.1 is active, and the status of the track entry
is positive. The static route configuration works.
# Remove the IP address of VLAN-interface 3 on Device B.
<DeviceB> system-view
[DeviceB] interface vlan-interface 3
[DeviceB-Vlan-interface3] undo ip address
# On Device A, display information about all track entries.
[DeviceA] display track all
Track ID: 1
Status: Negative
Notification delay: Positive 0, Negative 0 (in seconds)
Reference object:
NQA entry: admin test
Reaction: 1
# Display brief information about active routes in the routing table on Device A.
[DeviceA] display ip routing-table
Routing Tables: Public
Destinations : 4
Routes : 5
Proto Pre Cost
10.2.1.1 Vlan3
0 10.2.1.2 Vlan3
0 127.0.0.1 InLoop0
Direct 0 0
Direct 0 0
Routes : 4
52
NextHop Interface
127.0.0.1 InLoop0
127.0.0.1 InLoop0