Configuring Optional Parameters For An Nqa Test Group - HP 5820X Switch Configuration Manual

Configuring optional parameters for an NQA test
group
Optional parameters for an NQA test group are only valid for tests in this test group.
Unless otherwise specified, the following optional parameters are applicable to all test types.
To configure optional parameters for an NQA test group:
To do...
1. Enter system view.
2. Enter NQA test group view.
Enter test type view of a test
3.
group.
4. Configure the description for a
test group.
5. Configure the interval
between two consecutive tests
for a test group.
6. Configure the number of
probe operations to be
performed in one test.
7. Configure the NQA probe
timeout time.
8. Configure the maximum
number of hops a probe
packet traverses in the
network.
9. Configure the ToS field in an
IP packet header in an NQA
probe packet.
Use the command...
system-view
nqa entry admin-name operation-
tag
type { dhcp | dlsw | dns | ftp |
http | icmp-echo | snmp | tcp |
udp-echo | udp-jitter | voice }
description text
frequency interval
probe count times
probe timeout timeout
ttl value
tos value
31
Remarks
—
—
—
Optional.
By default, no description is
available for a test group.
Optional.
By default, the interval between
two consecutive tests for a test
group is 0 milliseconds. Only one
test is performed.
If the last test is not completed
when the interval specified by the
frequency command is reached, a
new test does not start.
Optional.
By default, one probe operation is
performed in one test.
Not available for voice tests. Only
one probe operation can be
performed in one voice test.
Optional.
By default, the timeout time is
3000 milliseconds.
Not available for UDP jitter tests.
Optional.
20 by default.
Not available for DHCP tests.
Optional.
0 by default.
Not available for DHCP tests.