Upgrading Pse Processing Software In Service - HP 5820X Switch Configuration Manual

To apply the PoE profile in system view:
To do...
1. Enter system view.
2. Apply the PoE profile to one
or multiple PoE interfaces.
To apply the PoE profile in interface view:
To do...
1. Enter system view.
2. Enter PoE interface view.
3. Apply the PoE profile to the
current PoE interface.
CAUTION:
A PoE profile can be applied to multiple PoE interfaces but a PoE interface can only be applied with
one PoE profile.

Upgrading PSE processing software in service

You can upgrade the PSE processing software in service in either of the following two modes:
refresh mode—enables you to update the PSE processing software without deleting it. You can
•
upgrade the PSE processing software in the refresh mode through the command line.
full mode—deletes the PSE processing software and reloads it. If the PSE processing software is
•
damaged (you can execute none of PoE commands successfully), you can upgrade the PSE
processing software in full mode to restore the PSE function.
In-service PSE processing software upgrade may be unexpectedly interrupted (for example, an error
results in device reboot). If you fail to upgrade the PSE processing software in full mode after reboot, you
can power off the device and restart it before upgrading it in full mode again. After upgrade, the new
PSE processing software take effect.
To upgrade the PSE processing software in service:
To do...
1. Enter system view.
2. Upgrade the PSE processing
software in service.
Use the command...
system-view
apply poe-profile { index index |
name profile-name } interface
interface-range
Use the command...
system-view
interface interface-type interface-
number
apply poe-profile { index index |
name profile-name }
Use the command...
system-view
poe update { full | refresh }
filename pse pse-id
92
Remarks
—
Required
Remarks
—
—
Required
Remarks
—
Required