HP 5820X Switch Configuration Manual page 30

Configuration prerequisites
UDP jitter tests require cooperation between the NQA server and the NQA client. Before you start UDP
jitter tests, configure UDP listening services on the NQA server. For more information about UDP listening
service configuration, see
Configuring UDP jitter tests
To configure UDP jitter tests:
To do...
1. Enter system view.
2. Enter NQA test group view.
3. Configure the test type as UDP
jitter and enter test type view.
4. Configure the destination
address of UDP packets.
5. Configure the destination port
of UDP packets.
6. Specify the source port
number of UDP packets.
7. Configure the size of the data
field in each UDP packet.
8. Configure the string to be
filled in the data field of each
probe packet.
9. Configure the number of
probe packets to be sent
during each UDP jitter probe
operation.
10. Configure the interval for
sending probe packets during
each UDP jitter probe
operation.
11. Configure the interval the
NQA client must wait for a
response from the server
before it regards the response
is timed out.
"Configuring the NQA
Use the command...
system-view
nqa entry admin-name operation-
tag
type udp-jitter
destination ip ip-address
destination port port-number
source port port-number
data-size size
data-fill string
probe packet-number
packet-number
probe packet-interval packet-
interval
probe packet-timeout packet-
timeout
20
server."
Remarks
—
—
Required.
Required.
By default, no destination IP
address is configured.
The destination IP address must be
the same as that of the listening
service on the NQA server.
Required.
By default, no destination port
number is configured.
The destination port must be the
same as that of the listening
service on the NQA server.
Optional.
By default, no source port number
is specified.
Optional.
100 bytes by default.
Optional.
By default, the string is the
hexadecimal number
00010203040506070809.
Optional.
10 by default.
Optional.
20 milliseconds by default.
Optional.
3000 milliseconds by default.