Table of Contents
Advertisement
Troubleshooting
5. Troubleshooting
PROBLEM
The machine cannot be started, or stops while
its running and cannot be restarted.
Low capacity or poor cutting results.
The cutting tool (3) cannot be removed.
The Agitator device (4:E), locking bolt (4:F)
or locking screw (4:G) cannot be removed.
16
MEASURES
Check that the plug is securely fitted into the power supply socket, or that
the isolating switch is closed . Press the starter button (2:B). Fit the feed
cylinder (1:E/1:F) and a feed attachment (1:A/1:B/1:C/1:D). Turn the feed
attachment locking knob (7:D/8:D) anti-clockwise to the locked position.
Move the push feed attachment feed plate (6:A) to the centre of the feed
cylinder. Check that all components are correctly fitted and that the safety
arm (2:F) is raised. Check that the fuses in the fuse box for the premises
have not blown, and that they have the correct rating. Wait for a few min-
utes and try to restart the machine. If the machine still fails to run, call a
specialist.
Make sure that you are using the correct cutting tool or combination of cut-
ting tools (3). Fit the decoring device (4:G), locking bolt (4:F) or agitator
device (4:E). Make sure that the speed controls for the machine (10:L) and
the pneumatic push feed attachment (10:M) are in the right position in ac-
cordance with the table under the heading setting the speed controls, and
that the reading on the pressure gauge (10:F) is about 4 bar. Check that the
pneumatc push feed attachment feed piston (10:I) is set to the right speed.
Position ¨1¨ - about 12 seconds/piston cycle, position ¨2¨ - about 8 seconds/
piston cycle, and position ¨3¨ - about 4 seconds/piston cycle. If necessary
the speed should be adjusted by a specialist. Check that the knives and
shredder plates are in good condition and are sharp. Press the food down
loosely.
Always use the ejector plate (4:A). Use a thick leather glove or the like that
the knives of the cutting tool cannot cut through, and turn the cutting tool
clockwise to release it.
Use a spanner (4:H) to unscrew it.
22.2.2007
Rev. 2.0
Advertisement
Table of Contents
