Table of Contents
Advertisement
Operation instructions
3.2.2 Periodic service
14
Check every week
•
That the machine stops when the locking handle (2:F) is lowered.
•
That the machine stops when the locking handle of the feed hopper attachment
(7:D) or the tube attachment (8:D) is turned clockwise to the unlocked position,
and that the machine restarts when the locking knob is turned anti-clockwise to the
locked position.
•
That the machine stops when the manual (1:C) or the pneumatic (1:D) push feed
attachment feeder plate (6:A) is swung to the side so that the feeder cylinder open-
ing (6:B) is greater than 60 mm, and that the machine restarts when the push feed
attachment is swung back over the feed cylinder.
•
Remove the plug from the power supply socket and then check that the electric ca-
ble is in good condition and is not craced on the outside.
If any of the two safety functions does not perform as intended or if the electric cable is
cracked, get a specialist to attend to the machine before connecting it back to the power
supply.
•
That the visible screws and bolts are securely tightened.
•
That the hinge pins (2:G) are adequately lubricated.
•
That the push feed attachment piston shaft (9:F) is clean and runs freely.
•
That the machine stands firmly on the adjustable feet.
•
Check that the knives and shredder plates are in good condition and sharp.
22.2.2007
Rev. 2.0
Advertisement
Table of Contents
