Table of Contents
Advertisement
Operation instructions
3.1.4 Fitting and removing the tube attachment (8:A)
•
•
•
•
•
3.1.5 Fitting and removing the manual push feed attachment (9:A)
•
•
•
•
•
•
3.1.6 Fitting and removing the pneumatic push feed attachment (10:A)
•
•
•
•
•
•
•
•
•
•
10
Press the stop button (2:C).
When fitting , fit the feed cylinder with three internal knives (1:F).
Place the tube attachment in the fed cylinder with the shaft (8:B) in the feed cyl-
inder tube (8:C).
Press down the tube attachmentand turn the locking knob (8:D) anti-clockwise.
When removing, turn the locking knob (8:D) clockwise and remove the tube at-
tachment.
Press in the stop button (2:C).
For fitting, fit the cylinder with three internal knives (1:F).
Move the lever (9:D) up all the way.
Fit the push feed attachment shaft (9:B) into the feed cylinder tube (9:C).
Press down the push feed attachment and swing it in anti-clockwise.
When removing, press down the stop pad (9:E) and swing out the push feed attach-
ment clockwise and remove it.
Press in the machine stop button (2:C).
When fitting, fit the feed cylinder with three internal knives (1:F).
Fit the push feed attachment shaft (10:B) into the feed cylinder tube (10:C).
Press down the push feed attachment and swing it anti-clockwise.
Push the compressor hose snap coupling (10:D) onto the push feed attachment nip-
ple (10:E).
Set the speed controls of the machine (10:L) and of the push feed attachment
(10:M) to suit the cutting tool being used as specified in the instructions under the
heading setting the speed controls (4.3.1).
Start the compressor and adjust its delivery pressure to 6 bar, and handle the com-
pressor in accordance with the manufacturer´s instructions.
Check the air pressure on the pressure gauge (10:F). the recommended air pressure
is about 4 bar, but the actual value needed may vary. If the air pressure reading on
the pressure gauge is different, pull the control (10:G) upwards and then turn it un-
til that the pressure gauge reading is around 4 bar, and then press it back down
again.
When removing, switch off the compressor and then disconnect the compressor
hose snap coupling (10:D) from the push feed attachment nipple (10:E).
Press down the stop pad (10:H) and swing out the push feed attachment clockwise,
and then remove it.
22.2.2007
Rev. 2.0
Advertisement
Table of Contents
