After Use; Cleaning - Metos RG-400 Installation And Operation Manual

Operation instructions

3.2 After use

3.2.1 Cleaning

•
•
•
•
•
•
•
•
Always wipe the knives of the cutting tools dry after use.
Never clean the cutting tools or other lightalloy objects with a detergent with a high pH
value (often used in dishwashers).
Never use sharp objects or a high-pressure spray gun for cleaning.
Never spray water on the sides of the machine.
Switch off the machine and remove the power supply plug from the socket or open
the isolating switch.
Carefully clean the machine immediately after use.
Remove the feed hopper agitator (7:E) by releasing the nut (7:F) by means of the
socket spanner (5:C).
Remove the two guides (1:K) and the three knives (1:L) by releasing the nuts
(1:M) by means of the socket spanner (5:C).
If you have used a dicing grid (3:G), leave it in the machine, and use the brush
(5:B) for pushing out any product remaining in the grid.
Remove the loose parts of the machine, wash them and dry them thoroughly.
Wipe the machine with a damp cloth.
Always store the cutting tools (3) on the hangers (4:A) on the wall.
22.2.2007 Rev. 2.0
13