Physical Printer - MPI linkcom 5 User Manual

LinkCom 5 User Manual
Code Page
Select the required value: Default is 500 (Multinational). Value has to match
corresponding value on the host system.
AFP Tray Mapping
AFP Tray Mapping is default set to 'Auto Configuration'. The available trays are
automatically imported from the trays defined in the Physical Printer definitions.
Trays can be re-mapped by disabling the 'Auto Configuration', clicking on the tray
name and selecting the required tray from the list. Only the tray type can be
remapped.
Emulation
Defines the IBM emulation which is reported to the IBM host system.
Select the value as required: IBM 3812, IBM 3816, IBM 4028.
LPI
Lines per inch.
CPI
Characters per inch
MPP
Maximum characters per page. Defines the maximum characters available per page
width.
MPL
Maximum lines per page.
LPI, CPI, MPP, and MPL values has to be typed in according to host requirements.
Edge to Edge Support
Will when checked inform the host that the output printer supports print from edge
to edge (even if the printer is not capable of this).
When used with PostScript print the PrintServer will (if needed) scale down the
print to ensure print data is within the allowed printable area.
When used with PCL the print data placed outside the allowed printable area may
be printed outside the actual paper. So use this option with consideration.
Suppress Blank Pages
Can be used to avoid unintended blank pages as well as separator sheets.
7.7.3

Physical Printer

These parameters are predefined when selecting the Printer Template (see 7.9
Printer templates). The Printer Template defines the target printer in the basic
version. These must be enabled or defined via the below panels before any
additional options installed in the printer can be accessed.
41
Page