Physical Printer - MPI linkcom 5 User Manual

LinkCom 5 User Manual
name and select the required tray from the list. Only the tray type can be
remapped.
End to end control
When checked it causes the PrintServer to receive information from the output
printer about the exact number of printed sheets. This information is sent back to
the host system according to host setup.
Edge to Edge Support
When checked it informs the host that the output printer supports print from edge
to edge (even if the printer is not capable of this).
When used with PostScript print the PrintServer will (if needed) scale down the
print to ensure print data is within allowed printable area.
When used with PCL print data that is outside the allowed printable area may be
printed outside the actual paper. So use this option with consideration.
7.5.3

Physical Printer

These parameters are predefined when selecting the Printer Template (see 7.9
Printer templates). The Printer Template defines the target printer in the basic
version. These must be enabled or defined via the below panels before any
additional options installed in the printer can be accessed.
When 'Auto Configure' is checked it will attempt to retrieve information about
Trays/Bins paper format etc. directly from the printer. After selecting this option,
save the changes and restart the PrintServer to collect information during
PrintServer start up. Enabling 'Auto Configure' disables manual configuration.
General Printer Parameters
30
Page