Grandstream Networks GVC3200 Administration Manual page 49

It is to configure device's setting to meet different vendors server requirements. Users
can choose from Standard, Broadsoft, CBCOM, RNK, China Mobile, ZTE IMS,
Special Feature
Mobotix, ZTE NGN, or Huawei IMS depending on the server type. The default setting
is "Standard".
It is used for the Broadsoft standard call feature synchronization. If it is enabled, the
device will send SIP SUBSCRIBE message to the server and receive SIP NOTIFY
Feature Key
Synchronization message from the server to synchronize the DND, Call Forwarding and Call Center
features. The default setting is "Disable".
If set to "Yes", call features (including call forwarding, DND and etc.) will be supported
locally instead of using the feature code supported on SIP server/proxy. For example,
Enable Call
if *72+number is dialed, the incoming calls will be forward to this number
Features
unconditionally. The default setting is "No". Refer to the chapter Call Features for
more details in the GVC3200/GVC3202 User Guide.
It is used to define the expiration timer (in seconds) for the rings with no answer. The
Ring Timeout (s)
default setting is 60.
Transfer on 3 way It is to set if the device will end the three-way conference hosted on it if it hangs up. If
set to "Yes", the conference will be transferred from hosted party, thus other parties
conference
Hangup can continue the conference without interruption. The default setting is unchecked.
It is used to set the device whether to use the "#" key as the "Send" key. If set to "Yes",
if the end user taps the "#" key on the remote control, the device will send out the
Use # as Dial Key typed digits. If set to "No", the "#" key is included as part of the dialing string and
please make sure the dial plan is properly configured to allow dialing # out. The default
setting is "Yes".
It is used to configure the network based conference URI (Broadsoft Standard). If it is
configured, end user needs to select MORE on the bottom menu in call interface and
Conference-URI
click on "N-way Conf" during the conference to transfer the host to the remote media
server.
It is used to load the MOH (Music on Hold) file to the device. Click on "Browse" button
to upload the music file from local PC. The MOH audio file has to be in .wav or .mp3
format.
Upload Local
MOH Audio File
Note:
Please be patient while the audio file is being uploaded. It could take more than 3
minutes to finish the uploading especially the file size is large. The button will show as
"Processing" during the uploading. Once done, it will show as "Browse" again. Click
on "Save" on the bottom of the web page and "Apply" on the top of the web page to
save the change.
If set to "Yes", the local MOH will be enabled. Users need to upload local MOH audio
Enable Local
file. Once enabled, users could play the file when holding the call. The default setting
MOH
is "No".
GVC3200/3202 Administration Guide
P a g e | 49