Grandstream Networks GVC3200 Administration Manual page 48

It is used to configure the prefix to be added to each dialed number. All numbers use
DialPlan Prefix this account will automatically add the prefix. e.g.: The prefix is 5, the phone number
is 337, and then the dial number is 5337.
Dial Plan Rules:
1. Accepted Digits: 1,2,3,4,5,6,7,8,9,0 , *, #
2. Grammar:
x - any digit from 0-9
xx - at least 2 digit numbers from 0-9
^ - exclude
[3-5] - any digit of 3, 4, or 5
DialPlan [147] - any digit of 1, 4, or 7
<2=011> -when the digit is 2, it will be replaced with 011
Set to {x+} allows dial out with all digits.
3. Example:
{[369]11 | 1617xxxxxxx} –- allows dialing numbers 311, 611 and 911 and 1617
area code
{^1900x+ | <=1617>xxxxxxx} –prevents dialing any number started with 1900 and
1617 area code will be added automatically when dialing number with 7 digits
length
It is used to set if the device will use the target's Contact header tag to the Refer-To
Refer-To Use
header in the SIP REFER message during an attended transfer. The default setting is
Target Contact
"No".
It is set to allow answering an incoming call. If it is set to "Yes", the device will
automatically enable the speaker phone to answer all the incoming calls after a short
Auto-Answer reminding beep. If set to "Enable Intercom/Paging", it will automatically answer the
incoming calls whose SIP INVITE includes auto-answer tag in the info header. The
default setting is "No".
It is used to set if the device will make an anonymous outgoing call. If it is set to "Yes",
Send Anonymous the "From" header in the SIP INVITE messages will be set to anonymous, essentially
blocking the Caller ID to be displayed. The default setting is "No".
Reject If it is set to "Yes", the device will reject the calls whose SIP INVITE message includes
Anonymous information in the From header. The default setting is "No".
Anonymous Call
It is used to categorize the call logs saved for this account. If it is set to "Log All", all
the call logs of this account will be saved. If set to Log Incoming/Outgoing Calls
(Missed Calls Not Record), the whole call history will be saved other than missed call.
Call Log
If it set to Disable Call All, none of the call history will be saved. The default setting is
"Log All".
GVC3200/3202 Administration Guide
P a g e | 48