11.18 Adjustment of the working pressure and the water volume in combination with the
motor speed
NOTE
The description for adjustment is done jointly for all unit
types. Deviations that must be observed with the unit types
HDS 13/20 and 17/20 are listed separately.
The technical data required for this is listed in Chapter 15.
Perform standard settings on the high-pressure pump
and the motor.
A = 20mm
B = 20mm
C = 75mm
1 Stop screw full load
2 Stop screw idle mode
D = 27,5mm
E = 18,5mm
Hand throttle lever
Insert test nozzle into the spray gun.
Attach rev counter to the motor.
Start the diesel engine.
NOTE
If the engine does not start, manually fill the engine with
diesel by means of the manual control on the fuel pump.
English 5.906-736.0 Rev. 00 (07/15)
173