Checking / Replacing The Level Sensor Fuel - Kärcher HDS 9/50 De Tr1 Service Manual

11.16.2 Checking / replacing the level sensor fuel

View with opened maintenance flaps
1 Level sensor for fuel tank
2 Support
3 Nut
 Unscrew both maintenance flaps.
 Unscrew 2 nuts.
 Unthread the holder, mind the cable while doing so.
 Carefully lever out the level sensor at the edge of the
upper rubber cuff along the girth of the branch using a
screwdriver.
ATTENTION
Risk of property damage! Do not pull the level sensor out
on the flap of the cuff, as this can get damaged in the pro-
cess due to the tight fitting!
 Pull out the level sensor from the tank towards the top.
1 Level sensor for fuel tank
 Detach the cable tie on the supply line so that there are
no constraints by cables upon unthreading.
 Push the level sensor up through the opening in the
cover of the air casing, then tilt it out towards the motor
compartment.
 Check the float switch at the sensor end for proper
function.
 If necessary, electrically disconnect and replace the
sensor, observe cable run!
English 5.906-736.0 Rev. 00 (07/15)
169