1 Fan wheel
2 Screw
Open the screw at the hub.
Pull the fan wheel off.
NOTE
Removing the fan wheel requires some force. Carefully
wobble the fan wheel all around and lever it out.
1 Fitting key
Remove the two feather keys of the motor shaft.
Unscrew 4 screws.
Remove the bottom part of the blower.
Unscrew 4 screws.
Push out the motor towards the back.
NOTE
When installing the branch, slide it approx. 1 cm into the
rubber cuff first, then position the console and screw it
down. Finally, slide the cuff approx. 2-3 cm over the
branch.
141
English 5.906-736.0 Rev. 00 (07/15)