10.6 Dismantling the front plate
For service tasks in the front area of the motor compart-
ment, it may be advisable to remove the front plate in order
90
English 5.906-736.0 Rev. 00 (07/15)
to enable better access to, for example, the safety block or
the fine filter in the pump inlet.
Unscrew the 2 x 3 screws for fastening the front plate
at the bottom.
1 Angle for locking the catch hook
Unscrew the 4 screws for fastening the front plate at the
top.
NOTE
Mind the angle for the lock of the catch hook, which is se-
cured to the frame by one of the above mentioned screws!
Upon installation, slide the angle in the elongated hole all
the way to the back and screw it down.
Remove the front plate towards the front.
View with dismantled front plate.