11.15.10Checking the oil level on the intermediate gear and refilling transmission oil
11.15.11Oil change intermediate gear
NOTE
Dispose of the waste oil according to the local provisions.
164
English 5.906-736.0 Rev. 00 (07/15)
1 Intermediate gear
2 Cover filling hole
3 Oil sight glass
4 Oil drain screw
Check the oil level in the intermediate gear.
If the oil level is below the oil looking glass, add oil.
Fill the appropriate amount of oil into the filling hole.
Check the oil level as described above.
Repeat this procedure as often as necessary until the
oil level is in the centre of the oil looking glass.
prescribed oil grades
Intermediate gear SAE 90
1 Intermediate gear
2 Cover filling hole
3 Oil sight glass
4 Oil drain screw
NOTE
Replace the oil while the motor has operating temperature.
Align the appliance horizontally prior to the oil change.
CAUTION
Risk of burns when draining hot oil.
Let the oil cool down to approx. 40 °C prior to changing the
oil.
Place a suitable container below the intermediate gear.
Turn out the oil drain screw.
Drain the waste oil completely.
Screw in the oil drain screw.
Unscrew cover of the filling hole.
Refill fresh oil.
Check oil level.
Screw in the cover of the filling hole.
Oil fill volume and type
Intermediate gear 0.35 litres, SAE 90