10.2 Install the device and align it
1 Parking brake
2 Plug storage
3 Crank for support wheel adjustment
Choose the installation site in a way that the exhaust gas
opening is not covered.
Lock parking brake.
Lower the support wheel by means of the crank.
Remove the tear-off rope from the towing vehicle.
Disconnect the connector from the vehicle lighting and
insert it into the plug storage on the drawbar.
Secure the machine with wheel chocks to prevent it
from rolling away.
Disconnect the towing vehicle.
Align the appliance horizontally with the support wheel.
ATTENTION
Risk of malfunctions and damages to the appliance. The
appliance must be in horizontal position during operation.
Place a spirit level on the drawbar for alignment.
1 Water pipes
2 High pressure hose
For service tasks without lance operation:
Disconnect the trigger gun from the high-pressure
hose.
Connect the high-pressure hose to the frost protection
inlet.
Disconnect the water hose from the water supply.
Connect the water hose to the return flow of the frost
protection.
English 5.906-736.0 Rev. 00 (07/15)
85