11.3 Covers
11.3.1 Replace the gas pressure damper
Rear cover
1 Fastening bolt with fork on the cover
2 Gas pressure damper
3 Fastening bolt with ball head on air casing
NOTE
The piston rod is installed towards the cover side.
1 Fastening bolt with fork on the cover
2 Splint
CAUTION
Risk of damage!
Secure the cover against falling shut uncontrolledly!
Do not open the hood too far, this may damage the hood
and the appliance. Ensure that the appliance is not lifted
up with the hood. The hood fastener is not suitable for this
kind of load and can tear.
Fastening at the top (fork): Push the cotter out on both
sides, pull out the bolt.
Fastening at the bottom (ball head): Unscrew nut.
Exchange the gas pressure damper.
NOTE
Ensure that the gas pressure damper runs in a straight
line; if necessary, adjust with lock nut.
English 5.906-736.0 Rev. 00 (07/15)
97