Configuring Alarm Output - HIKVISION UD00543B User Manual

2. Choose the alarm input No. and the Alarm Type. The alarm type can be NO
(Normally Open) and NC (Normally Closed). Edit the name to set a name for the
alarm input (optional).
3. Click Arming Schedule to set the arming schedule for the alarm input. Refer to
Task 2: Set the Arming Schedule for Motion Detection in Section 9.1.1.
4. Click Linkage Method and check the checkbox to select the linkage method
taken for the alarm input. Refer to Task 3: Set the Linkage Method for Motion
Detection in Section 9.1.1.
5. You can click Copy to to copy your settings to other alarm inputs.
6. Click Save to save the settings.

9.1.4 Configuring Alarm Output

Steps:
1. Enter the Alarm Output Settings interface:
Event > Alarm Output.
2. Select one alarm output channel in the Alarm Output drop-down list. You can
also set a name for the alarm output (optional).
3. The Delay time can be set to 5sec, 10sec, 30sec, 1min, 2min, 5min, 10min or
Manual. The delay time refers to the time duration that the alarm output remains
in effect after alarm occurs.
4. Click Arming Schedule to enter the Edit Schedule Time interface. The time
schedule configuration is the same as the settings of the arming schedule for
motion detection Refer to Task 2: Set the Arming Schedule for Motion Detection
in Section 9.1.1.
5. You can copy the settings to other alarm outputs.
6. Click Save to save the settings.
Network Multi-Sensor Panoramic Dome Camera
Configuration> Event > Basic
92