Table of Contents
Advertisement
Network Multi-Sensor Panoramic Dome Camera
Chapter 6 Network Settings
Purpose:
Follow the instructions in this chapter to configure the basic settings and advanced
settings.
6.1 Configuring Basic Settings
Purpose:
You can configure the parameters, including TCP/IP, DDNS, PPPoE, Port, and NAT,
etc., by following the instructions in this section.
6.1.1 Configuring TCP/IP Settings
Purpose:
TCP/IP settings must be properly configured before you operate the camera over
network. The camera supports both the IPv4 and IPv6. Both versions can be
configured simultaneously without conflicting to each other, and at least one IP
version should be configured.
Steps:
1.
Enter TCP/IP Settings interface:
Configuration > Network > Basic Settings > TCP/IP
51
Advertisement
Table of Contents
