Table of Contents
Advertisement
9.1.2 Configuring Video Tampering Alarm
Purpose:
You can configure the camera to trigger the alarm when the lens is covered and take
certain alarm response actions.
Steps:
1. Enter the video tampering Settings interface, Configuration > Event > Basic
Event > Video Tampering.
2. Check Enable Video Tampering checkbox to enable the video tampering
detection.
3. Set the video tampering area. Refer to Task 1: Set the Motion Detection Area in
Section 9.1.1.
Network Multi-Sensor Panoramic Dome Camera
Figure 9-6 Video Tampering Alarm
90
Advertisement
Table of Contents
