Network Setup; Configuring The Wired Network - Kyocera TASKalfa 2552ci Operation Manual

Hide thumbs Also See for TASKalfa 2552ci:

Table of Contents

Installing and Setting up the Machine > Network Setup

Network Setup

The machine is equipped with network interface, which is compatible with network protocols such as TCP/IP (IPv4),

TCP/IP (IPv6), NetBEUI, and IPSec. It enables network printing on the Windows, Macintosh, UNIX and other platforms.

Set up TCP/IP (IPv4) to connect to the Windows network.

Be sure to connect the network cable before configuring the settings.

Connecting LAN Cable (page 2-7)

For other network settings, refer to the following:

Network (page 8-48)

If user login administration is enabled, you can only change the settings by logging in with administrator privileges.

If user login administration is disabled, the user authentication screen appears. Enter a login user name and

password, and select [Login].

The factory default login user name and login password are set as shown below.

IPv4 setting

Display the screen.

[System Menu/Counter] key > [System/Network] > "Network" [Next] > "Wired Network

Settings" [Next] > "TCP/IP Setting" [Next] > "IPv4" [Change]

Configure the settings.

When using DHCP server

[DHCP]: Set to [On].

When setting the static IP address

[DHCP]: Set to [Off].

[IP Address]: Enter the address.

[Subnet Mask]: Enter the subnet mask in decimal representation (0 to 255).

[Default Gateway]: Enter the address.

When using the Auto-IP, enter "0.0.0.0" in [IP Address].