Obtain Nw User Property - Kyocera TASKalfa 2552ci Operation Manual

User Authentication and Accounting (User Login, Job Accounting) > Setting User Login Administration

Obtain NW User Property

Set the required information to obtain the network user property from the LDAP server. The user name and E-mail
address obtained with this setting is shown in the user information, the status confirmation screen, and the header of
E-mail.
NOTE
To obtain the network user property from the LDAP server, [Network Authentication] must be selected for the
authentication method in "Enabling User Login Administration". Select "On" for "LDAP" in "Protocol Detail".
Enabling User Login Administration (page 9-3)
Protocol Settings (page 8-55)
1
2
Display the screen.
1
[System Menu/Counter] key > [User Login/Job Accounting]
NOTE
If the login user name entry screen appears during operations, enter a login user name
and password, and select [Login]. For this, you need to login with administrator
privileges.
The factory default login user name and login password are set as shown below.
Model Name
2552ci
3252ci
4052ci
5052ci
6052ci
2
[User Login Setting] > [Obtain NW User Property] > [On]
Configure the settings.
[On] > Add information on each item > [OK]
Item
*1
Server Name
Port
*2
Name 1
*3
Name 2
*4
E-mail Address
Login User Name
2500
3200
4000
5000
6000
Enter the LDAP server name or the IP address (up to 64
characters). If a server name is not entered, user information will
be acquired from the server set for Network Authentication.
Port number for LDAP server. The default port number is 389.
Enter the LDAP Attribute to obtain the user name to be displayed
from the LDAP server (up to 32 characters).
Enter the LDAP Attribute to obtain the user name to be displayed
from the LDAP server (up to 32 characters).
Enter the LDAP Attribute to obtain the E-mail address from the
LDAP server (up to 32 characters).
9-26
Login Password
2500
3200
4000
5000
6000
Descriptions