Setting Way Point - Kenwood TH-D74A User Manual

Turn time
Minimum time delay between each beacon transmission by
change of direction.
1 Access Menu No. 535.
2 Select from [5] to [180] seconds.
Note:
◆ Adjust the Setting values to match the actual driving status.
SmartBeaconing Operation:
Speed
Above the <High
Speed>
Under <High Speed>
Over <Low Speed>
(Only when the set
<High Speed> ≧ <Low
Speed>)
Below the <Low Speed> <Slow Rate>
Transmission Interval Example:
(with <Low Speed> = 5, <High Speed> = 70, <Slow Rate> =
30 min, <Fast Rate> = 120 sec)
Speed
80 120 seconds (2 minutes)
70 120 seconds (2 minutes)
50 168 seconds (2 minutes 48 seconds)
30 280 seconds (4 minutes 40 seconds)
20 420 seconds (7 minutes)
10 840 seconds (14 minutes)
5 1680 seconds (28 minutes)
0 1800 seconds (30 minutes)
Corner Pegging Operation Example:
(with <Turn Angle> = 30° <Turn Slope> = 24)
<Turn
<Turn
Speed Slope> ÷
Slope>
Speed (1)
60 24 (x10) 4°
50 24 (x10) 6°
30 24 (x10) 8°
20 24 (x10) 12°
10 24 (x10) 24°
5 24 (x10) 48°
• When the value of "Turn Threshold" exceeds 120°, it is
calculated as 120°.
Transmission Corner
Interval Pegging
Operates
<Fast Rate>
normally
The interval is
calculated using
the following
formula:
Operates
normally
(Transmission
Interval = <Fast
Rate> x <High
Speed> ÷ Speed)
Will not
operate
Interval
Turn
<Turn
Threshold
Angle> (2)
(3)=(1)+(2)
30° 34°
30° 36°
30° 38°
30° 42°
30° 54°
30° 78°

SETTING WAY POINT

A waypoint refers to a point that is registered in external
devices with a name being assigned to specific position
coordinates.
By outputting the Callsigns of other stations received by
the transceiver and the position data as waypoint data,
these information can be displayed on GPS receivers with
display screen and tablet screens where APRS application is
installed.
Way Point Format
Select the type of Way point Format that is sent.
1 Access Menu No. 540.
2 Select [NMEA], [MAGELLAN] or [KENWOOD].
NMEA]: The data using the NMEA 0183 "$GPWPL"
format.
[MAGELLAN]: The data using the " $PMGNWPL" format.
[KENWOOD]: The data using the " $PKWDWPL" format.
Way Point Length
Select the length of the Way Point Name.
1 Access Menu No. 541.
2 Select [6-Char], [7-Char], [8-Char], or [9-Char]
Way Point Output
Select the Way Point output type.
1 Access Menu No. 542.
2 Select [All], [Local], or [Filtered]
[All]: All Way point information is sent.
[Local]: If the position limit is ON, all the data within the
position limit is sent. If the position limit is OFF, all Way
point data is sent.
[Filtered]: Information that is permitted using the packet
filter is output as Way point information.
14-18