Beep Volume; Battery Saver; Auto Power Off (Apo); Battery Level - Kenwood TH-D74A User Manual

BEEP VOLUME

You can set the beep volume.
1 Access Menu No. 915.
2 Select among from [Level 1] to [Level 7].

BATTERY SAVER

The Battery Saver extends the operating time of the
transceiver. It automatically activates when the squelch is
closed and no key is pressed for more than 5 seconds. To
reduce battery consumption, this function shuts the receiver
circuit OFF for the programmed time, then momentarily turn it
back ON to detect a signal.
To program the receiver shut-off period for the battery saver:
1 Access Menu No. 920.
2 Select [0.2], [0.4], [0.6], [0.8], [1.0], [2.0], [3.0], [4.0], [5.0]
seconds, or [Off].

AUTO POWER OFF (APO)

Automatic Power off is a background function that monitors
whether or not any operations have been performed
(keys pressed, [ENC] control turned, etc.), and turns the
transceiver power off if it has not been in use.
To program the receiver shut-off period for the battery saver:
1 Access Menu No. 921.
2 Set the APO time limit to [15], [30], [60] minutes, or [Off].
• After the time limit passes with no operations (default is
[Off]), APO turns the transceiver power off. However,
1 minute before the power turns off, [APO] appears on
the display and blinks, and a warning tone sounds.
Note:
◆ A warning tone sounds when a Key Beep is set to Off.
◆ Automatic Power Off does not operate in scanning.

BATTERY LEVEL

You can verify the battery capacity while in Menu mode.
1 Access Menu No. 922.
Note:
◆ You can check the remaining battery level by voice guidance.
Refer to page No. 23 "voice guidance" section.
12-10