Tx Messages; Tx History; Call Within Zone - Kenwood TH-D74A User Manual

Displaying the RX History
1 Access Menu No. 600.
2 Select a list and press [A/B].
The RX history details screen appears.
3 Press [A/B].
The RX history GPS screen appears.
Registering the Callsign from the RX History
1 Access Menu No. 600.
2 Select the list and press [ENT].
The Callsign registration screen appears.
Clearing the RX History
1 Access Menu No. 600.
2 Select the list and press [MODE].
The selected RX history are cleared.
All RX history are cleared by pressing [MODE] (1s).

TX MESSAGES

A message of up to 20 characters can be transmitted
during voice communications in DV/DR mode. Up to five
transmission messages can be registered.
Registering the TX Messages
1 Access Menu No. 611.
2 Select a number for registration and press [A/B].
The TX message editing screen appears.
3 Enter the messages.
4 Select a number for registration and press [ENT].
The TX messages is selected
Each press of [PTT] transmits the selected message.

TX HISTORY

Up to 20 entries can be stored in TX history for signals
transmitted in DV/DR mode. The TX history is not cleared
when the power is switched off.
Once transmitted, a combination of Callsigns (FROM and
TO) is stored together, so you can restore the transmission
settings of that time with one touch by pressing [A/B] for the
selected TX history.
Displaying the TX History
1 Select [TX History] in the Digital Function Menu.
The TX history list screen appears.
2 Select a list and press [A/B].
The transmission settings are changed and return to the
frequency screen.
Note:
◆ Entries are not stored in TX history for the data mode, Callsign
squelch/ Code squelch, and BK call.
Clearing the TX History
1 Select [TX History] in the Digital Function Menu.
2 Select the list and press [MODE].
The selected TX history are cleared.
All TX history are cleared by pressing [MODE] (1s).

CALL WITHIN ZONE

Call within Zone is an indirect communication via a different
repeater within the zone.
Note:
◆ Call within Zone is not connected with the Internet
Setting the Access Repeater (FROM)
1 Select [Route Select] in the Digital Function Menu.
2 Select [Local NW] and press [ENT].
The world region selection screen appears.
3 Select your region and press [ENT].
The country region selection screen appears., country,
and group selection screen appears.
4 Select your country and press [ENT].
The group selection screen appears.
5 Select your area group and press [ENT].
The repeater list selection screen appears.
6 Select a nearby repeater from the repeater names or
state/prefecture names and press [ENT].
The access repeater is set to [FROM].
16-6
.