Cross Tone - Kenwood TH-D74A User Manual

2 Press [F], [TONE] (1s).
"
• Scan starts and Scanning
• To quit the scan, press [ ].
• When a DCS code is identified, the identified code
appears on the display and blinks.
3 Press [A/B] to program the identified code in place of the
currently set DCS code.
• The DCS function will remain on. To cancel DCS,
press [TONE] until DCS no longer appears on the
display.

CROSS TONE

Using Cross Tone
You can set separate signaling types by TX and RX for when
you access a repeater that uses different Encode/ decode
signaling.
To turn the Cross Tone function On:
1 Press [TONE] 4 times to activate the Cross Tone function.
• The < (default) icon appears on the display when
>
the Cross Tone function is On.
• Each time you press [TONE], the selection changes as
follows:
Tone ( ) ➡ CTCSS (
Tone ( : default) ➡ Off (no display).
Additionally, when APRS is ON and Voice Alert is
configured, Voice Alert ON is added to the above cycle.
Selecting a Cross Tone mode
To select the cross tone/code frequency required to access
your desired repeater:
1 Turn the Cross Tone function On.
2 Press [F], [TONE].
• The Cross Tone setting appears on the display.
3 Select your desired Cross Tone setting.
Setting Encode
DCS/Off DCS
TONE/DCS Tone
DCS/CTCSS DCS
TONE/CTCSS Tone
4 Press [A/B] to set the selected setting.
"
blinks on the display.
) ➡ DCS ( ) ➡ Cross
Decode Icon
off
DCS
CTCSS
CTCSS
10-3