Adjusting The Projector's Elevator - Christie LW502 Setup Manual

Adjusting the projector's elevator

When the place to put the projector is slightly
uneven to the left or right, use the elevator feet to
place the projector horizontally. Using the feet can
also tilt the projector in order to project at a
suitable angle to the screen, elevating the front
side of the projector within 11 degrees.
This projector has 2 elevator feet and 2 elevator buttons. An elevator foot is
adjustable while pushing the elevator button on the same side as it.
1.
Holding the projector, push the elevator buttons to loose the elevator feet.
2.
Position the front side of the projector to the desired height.
3.
Release the elevator buttons in order to lock the elevator feet.
4.
After making sure that the elevator feet are locked, put the projector down
gently.
5.
If necessary, the elevator feet can be manually twisted to make more precise
adjustments. Hold the projector when twisting the feet.
To loose an elevator foot,
push the elevator button
on the same side as it.
CAUTION ►Do not handle the elevator buttons without holding the
projector, as the projector may drop down.
►Do not tilt the projector other than elevating its front within 11 degrees using
the adjuster feet. A tilt of the projector exceeding the restriction could cause
malfunction or shortening the lifetime of consumables, or the projector itself.
LW502/LWU502/LX602 Setup Guide
020-001101-03 Rev. 1 (02-2018)
11°
To fi nely adjust,
twist the foot.
13