Adjusting The Projector's Elevator; Remote Control - Christie LX400 User Manual

Adjusting the projector's elevator

Use the elevator feet to place the projector horizontally. Using the feet
can also tilt the projector in order to project at a suitable angle to the
screen, elevating the front side of the projector within 8 degrees.
This projector has 2 elevator feet and 2 elevator knobs. An elevator
foot is adjustable while pulling up the elevator knob on the same side
as it.
1. To loose an elevator foot, pull up the elevator knob on the same
side as it.
2. Position the front side of the projector to the desired height.
3. Release the elevator knobs in order to lock the elevator feet.
4. To finely adjust, twist the foot.
WARNING
►Do not handle the elevator knobs without holding the projector, since the
projector may drop down.
►Do not tilt the projector other than elevating its front within 8 degrees using
the adjuster feet. A tilt of the projector exceeding the restriction could cause
malfunction or shortening the lifetime of consumables, or the projector itself.

Remote control

Laser pointer
The laser beam is emitted and the LASER INDICATOR lights while the LASER button is
pressed.
WARNING
►Never hit an eye with the laser beam, and use the laser pointer except to
serve as a pointer to a screen. The laser beam can cause vision problems, and
also may cause radiation exposure.
LX400 User Manual - Concise
LASER INDICATOR
LASER button
5
020-000166-02 Rev. 1 (08-2009)
8°
The laser beam outlet