Adjusting The Projector's Elevator; Installation Angle - Christie LWU620i User Manual

Operating

Adjusting the projector's elevator

Increasing or shortening the length of
the elevator feet shifts the projection
position and the projection angle.
Turn the elevator feet each to adjust
their length.
5°
5°
WARNING
►Do not lengthen the elevator feet exceeding 30 mm. The foot
lengthened exceeding the limit may come off and drop the projector down, and
result in an injury or damaging the projector.
CAUTION
degrees. The projector leaned exceeding the limit could cause malfunction and
shorten the life of the projector.

Installation angle

10°
10°
10° 10°
LWU720i/LHD720i/LWU620i
User's Manual - Operating Guide
►Do not place the projector with an inclination exceeding 5
max. 30mm
Lamp side
Vertical and horizontal direction in
portrait mode
The projector may be installed at
horizontal angle of ±10°.
The projector may be installed at
vertical angle of ±10°.
NOTE
projector must face upward for
vertical installations.
• If Other Error has occurred,
check the installation. Install the
projector correctly and restart it.
• When using portrait mode, the
service life of a lamp becomes
shorter.
40
• The lamp side of the
020-001279-01 Rev. 1 (10-2017)