Adjusting The Projector's Elevator - Christie LX41 Setup Manual

Adjusting the projector's elevator

When the place to put the projector is slightly uneven to
the left or right, use the elevator feet to place the projector
horizontally. Using the feet can also tilt the projector
in order to project at a suitable angle to the screen,
elevating the front side of the projector within 12 degrees.
This projector has 2 elevator feet and 2 elevator buttons.
An elevator foot is adjustable while pushing the elevator
button on the same side as it.
1. Holding the projector, push the elevator buttons to
loose the elevator feet.
2. Position the front side of the projector to the desired
height.
3. Release the elevator buttons in order to lock the
elevator feet.
4.
After making sure that the elevator feet are locked,
put the projector down gently.
5. If necessary, the elevator feet can be manually
twisted to make more precise adjustments. Hold the
projector when twisting the feet.
CAUTION ►Do not handle the elevator buttons without holding the
projector, since the projector may drop down.
►Do not tilt the projector other than elevating its front within 12 degrees using
the adjuster feet. A tilt of the projector exceeding the restriction could cause
malfunction or shortening the lifetime of consumables, or the projector itself.
LX41/LW41 Setup Guide
To loose an
elevator foot, push
the elevator button
on the same side
as it.
To fi nely
adjust, twist
the foot.
9
020-000510-01 Rev. 1 (06-2012)