Colormax Setting - Digital Projection E-Vision Laser 7500 Series User Manual

Digital Projection E-Vision Laser 7500 & 8500 Series
Color menu continued from previous page

ColorMax Setting

ColorMax Setting

permits seven point
color matching of red, green, blue,
yellow, cyan, magenta and white.
You can enter your own gamut values
here, or edit values you have imported
using the Projector Controller
software.
Defining your own colorspace with
individual x and y coordinates for each
color enables you to match not only the
whites but each individual color as well.
Highlight the submenu you wish to
open and press to confirm
ENTER/OK
your choice.
Measured Data / Target Data
1. Use the UP and DOWN arrow
buttons to highlight a color, then
use the and
LEFT RIGHT
arrow buttons to navigate to the x
or y coordinate.
2. Use the and arrow
UP DOWN
buttons to increase and decrease
the value, respectively.
3. Exit edit mode:
•
press ENTER/OK , if you want
to save the edited values.
•
press , if you do not wish
EXIT
to save the edited values
4. If necessary, highlight another color
and repeat the procedure.
Operating Guide
Measured Data
Red x: 0.658 y: 0.339
Green x: 0.315 y: 0.662
Blue x: 0.146 y: 0.043
White x: 0.276 y: 0.283
USING THE PROJECTOR
ColorMax Setting
Measured Data
Target Data – User 1
Target Data – User 2
Reset
Target Data – User 1
Red
Green
Blue
Yellow
Cyan
Magenta
White
u
u
The Projector Controller software
u
is available for download from the
Digital Projection website, free of
charge.
This tool is best used in conjunction
with a specialized light meter (a
photo spectrometer) to measure
color parameters within a particular
installation. However, the preloaded
generic factory default data set
is designed to give more than
satisfactory results.
x: 0.640 y: 0.390
x: 0.300 y: 0.600
x: 0.150 y: 0.060
x: 0.419 y: 0.505
x: 0.225 y: 0.329
x: 0.321 y: 0.154
x: 0.285 y: 0.302
Notes
Rev B September 2016
page 65