Assembly Instructions - Body Solid GLGS100 Owner's Manual

S T E P
1
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Finger tighten all hardware in this step. DO NOT wrench tighten until instructed.
Some components may be pre-assembled. Nylon lock nuts will not fully screw onto
bolts, they must be wrench tighten to fully go on.
1A. Attach Left & Right Base Frames (B & C) to LOWER UPRIGHT (A) using:
2 - (#1) M12x100mm Hex Head Bolt
4 - (#14) M12 Flat Washer
2 - (#12) M12 Nylon Lock Nut
1B. Attach Foot Plate (D) to Left & Right Base Frames (B & C) using:
4 - (#1) M12x100mm Hex Head Bolt
8 - (#14) M12 Flat Washer
4 - (#12) M12 Nylon Lock Nut
12