Advertisement
S T E P
1
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Wrench tighten ALL hardware at the end of STEP 1B. Some components may be
pre-assembled. Nylon lock nuts will not fully screw onto bolts, they must be wrench
tighten to fully go on.
1A. Attach Side Base Frames (B) to Center Base Frame (A) using:
4 - (#1) M10x75mm Hex Head Bolt
8 - (#4) M10 Flat Washer
4 - (#5) M10 Nylon Lock Nut
2 - (E) Steel Plate
1B. Attach Upright (C) to Center Base Frame (A) using:
2 - (#1) M10x75mm Hex Head Bolt
2 - (#3) M10x20mm Hex Head Bolt
6 - (#4) M10 Flat Washer
2 - (#5) M10 Nylon Lock Nut
1C. Insert Square End Cap (#6) into Upright (C) using:
8
Advertisement
